I’d like to put here some consideration about the imu calibration, that means how it is mounted the imu on the drone respect the propeller plane. This information is fundamental to garanty a perfect hover position without lateral mevement of the drone.
In other words, if I set roll=0 and pitch=0 I want that the prop plane is aligned with the world, evenif the sensor can be not perfectly aligned with the world (and also with the propeller plane).
In this pictures you can see this case: the world (blue) , the sensor (red) and the prop plane ( orange).
In the next picture let’s put some manes to the angles:
Important: Note that gamma is the angle measured by the accelerometer.
The most important information I need to know is the angle beta : the offset between the sensor and the prop plane . this is the error generated to the mechanical installation of the imu.
This value is used to compensate the measured value from the accelerometer.
alpha and beta are the 2 unknowns so I need 2 equations to solve this problem.
I decide to use this simple method to calibrate imu:
1) Take a reference plane ( my kitchen table) . It does not metter if it is not perfect alingned to the world, it is just enough it is stable.
2)Place from behind the prop plane on the “table roof”.
3) Measure the angles of the accelerometer (gamma1).
4)turn the drone 180 degree respect yaw and place it again on the table roof.
5)Measure the angles again ( gamma2) .
6)consider that, in those 2 measurements, the alpha angle is constant ( i do not move the table…) , while the angle beta is equal but inverted ( due to the rotation of the drone).So the result is:
In order to manage this method in a easy way I added in the code the option called “fine calibration” .
The last version is now on github.
Just run the myQrc.py , move to the new mode “IMU” and follow the instructions.